Roadrunners operational document
Handling and Lifting Goods Risk Assessment
Reference RRD-RAMS-01, issue 2. This assessment applies to routine handling of packaged goods into and out of cars and vans at collection and delivery premises.
Reviewed 3 October 2026
These are general planning controls. The task, load, people, vehicle and location must be checked for every job. Specialist goods, abnormal loads, cranes and forklift work require separate arrangements.
Download the unsigned risk assessmentResponsibilities
Management provides suitable equipment, information, instruction and task assessment. Drivers follow this method, agree local arrangements with the customer or site contact, and stop and contact the office if conditions are unsafe. Only trained and authorised people may operate lifting equipment.
Assessment method
The assessment identifies who may be harmed and scores likelihood and severity on a 1-to-5 scale. The two scores are multiplied to give the risk rating. Controls must reduce risk so far as is reasonably practicable; higher residual risks require management attention and may require the work to stop.
Safe working method
- Plan the task: confirm weight, dimensions, contents, stability, grip, access and the assistance required. Avoid hazardous manual handling where possible.
- Make the area safe: park on firm level ground, apply the parking brake, control vehicle movement and separate people from traffic.
- Inspect doors, load space, restraints, trolleys, ramps and tail lifts. Observe payload, axle and equipment limits.
- Use a trolley or other suitable aid first. If manual lifting is suitable, keep the load close, use a stable grip and stance, avoid twisting and never carry a load that blocks vision.
- Keep clear of pinch points and raised loads. Open doors cautiously, check for shifted goods, load evenly and secure goods against movement.
- Confirm safe placement, recheck remaining load security, clear the area and report injuries, near misses, damage or unsafe conditions.
Principal hazards and controls
- Heavy, awkward or repeated handling: check capability and handling factors, use aids, smaller loads or planned assistance, and pause for fatigue.
- Slips, trips and falls: inspect the route, maintain lighting and grip, remove obstructions and stop if safe access cannot be provided.
- Moving vehicles: use designated loading areas, parking brakes, site controls and high-visibility clothing where required.
- Falling or shifting goods: check stability before opening doors or releasing restraints; stack and secure loads and never stand beneath a raised load.
- Doors, restraints and load edges: inspect packaging, use suitable gloves, control doors in wind and use stable set-down points.
- Trolleys, ramps and tail lifts: use suitable equipment within capacity, with trained operators and current inspection or maintenance.
- Poor conditions or unsuitable capability: consider space, slope, weather, lighting, fatigue and health restrictions; adapt, assist, postpone or stop.
- Leaking or damaged packages: do not touch unidentified substances; isolate the area, notify the site and office, and use a separate goods-specific procedure where required.
Emergency stop rule
Stop if the load, route, equipment or handling ability is unsafe. Make the area safe without putting yourself at risk, obtain first aid and call 999 for a serious emergency. Do not handle leaking or unidentified hazardous goods.
Review
Review by 3 October 2027, or sooner following an incident, changed loads or equipment, a material change in working conditions, or evidence that the controls are not effective.
Assessment and approval
Assessed and approved by Tim Watson, Despatch Manager, on 3 October 2026. This public copy is unsigned; the controlled master is retained by Roadrunners.
